How to avoid UV damage during the operation of UV glue

In the process of operating UV glue, the following methods can be used to avoid UV damage:

1. When storing UV glue, pay attention to the ventilation and light-proof storage environment to avoid the unpleasant odor of UV glue and prevent ozone accumulation.

2. When operating UV curing glue, the equipment used for curing should have appropriate shielding devices, so that ultraviolet light is not so easy to penetrate. For example, use a closed UV curing oven instead of direct UV lamp, or use an assembly line curing equipment without manual operation.

3. When operating UV curing glue, the operator should wear personal protective clothing, long-sleeved clothes, cloth work gloves, UV-proof glasses, masks, do not look directly at the UV light source, take appropriate protective measures, and minimize the damage caused by ultraviolet rays.

1. Product Introduction

KL-16UV adhesive has the advantages of quick drying, easy use, strong bonding, no VOC emissions, etc. It is mainly used for PET to PET, PET to ABS, PET to PC, PET to acrylic, etc.

2. Usage

1. Make sure the bonded surface is clean, dry, grease-free and flat

2. Apply an appropriate amount of UV adhesive to the surface of the bonded workpiece, then close it with another bonded workpiece and remove possible bubbles

3. When the two bonded workpieces are pressed tightly, they are exposed to a certain intensity of UV lamp or sunlight to solidify the UV adhesive on the bonding surface

3. Precautions

1. Grease, moisture, impurities and flatness on the surface of the workpiece will directly affect the bonding quality. Be sure to wipe it dry and clean to ensure that the bonding surface is flat.

2. When working in rainy weather, be sure to ensure that the workpiece is clean and dry. It is strongly recommended to use a special shadowless glue curing lamp for light curing to ensure the bonding quality.

3. During the bonding process, be sure to remove possible bubbles; during the light curing process, ensure that the bonded parts can be exposed to UV light or sunlight. Be sure to press the bonded workpiece tightly. The thinner the glue layer is, the better the bonding force.

4. Before positioning the bonded workpiece, do not move it under U light or sunlight to avoid whitening and affecting the appearance. It is recommended to use a clamp.