How to deal with silicone treatment agent

The treatment of silicone treatment agent mainly involves the steps of preparing the silicone surface, applying the treatment agent, drying and subsequent processing. The following are specific treatment methods:

1. Preparation: First, the silicone surface needs to be cleaned to ensure that there are no impurities such as dust and oil. Solvents or clean water can be used for cleaning so that the treatment agent can better adhere to the silicone surface.

Stirring and applying: According to the manufacturer's instructions, stir the silicone treatment agent thoroughly and ensure that the ingredients are fully mixed.

Then, use a spray gun, brush or other suitable tools to evenly apply the treatment agent to the silicone surface. Pay attention to the uniform application to ensure that every part is applied to avoid bubbles and uneven coating.

2. Drying: After the application is completed, place the silicone at room temperature to dry naturally.

The drying time may vary depending on the different silicone treatment agents. It usually takes a few minutes to a few hours to wait. The specific time should be determined according to the product instructions. During the drying process, care should be taken to avoid dust contamination.

3. Subsequent processing: After drying, secondary processing such as molding, cutting, stamping, etc. can be carried out to ensure that the size and shape of the silicone products meet the requirements.

In addition, when using silicone treatment agents, you should also pay attention to the following points:

Avoid contact of the treatment agent with eyes and skin to avoid discomfort.

Follow product instructions and safe operating procedures to avoid product quality problems caused by misoperation.

If you encounter abnormal conditions during use, you should stop using it immediately and report it to the relevant departments in a timely manner.

Finally, when storing silicone treatment agents, they should be placed in a cool and dry place, away from fire, heat sources and direct sunlight to prevent fire or affect product quality. At the same time, ensure that the storage place has good ventilation and the room temperature should be below 30°C.

Please note that the above is only a general treatment method, and the specific operation may vary depending on factors such as the type of silicone treatment agent, the material and purpose of the silicone.

Therefore, in actual operation, it is recommended to read the product manual carefully and follow the manufacturer's advice and guidance.

Silicone surface treatment agent
Product model: K770-3
Packing specification: 1000ml/bottle;
Product features: fast bonding, strong adhesion, low whitening;
Bonding process: Treat the silicone surface at room temperature;
Suitable materials: Surface treatment of some elastic materials such as silicone rubber (silicone rubber, silicone)
Common applications: Bonding of silicone rubber with ABS plastic, metal, plastic and other materials