What is Plastic PC Adhesive

Plastic PC adhesive is a kind of glue specially used for bonding PC plastic. It has the advantages of high bonding strength, fast curing, and good temperature resistance.

This adhesive is widely used in electronic products, automobiles, home appliances and other fields. For more information about "plastic PC adhesive", you can go to Kanglibang's official website to find relevant content.

Advantages of silicone and PC adhesive:

1: Strong adhesion, no debonding after more than 100 grid tests, no separation by knife cutting.

2: Low odor, environmentally friendly formula, no irritating odor!

Where is silicone PC adhesive used?

※Silicone diving products (diving glasses, diving masks, gas masks, etc.

Silicone PC masks

※Silicone baby products (silicone gifts)

※Silicone 3C electronic products (Silicone PC two-in-one mobile phone case, silicone PC waterproof key is not limited to card tray, waterproof side key, earpiece, battery seal)

How to make silicone stick firmly:

1. This product is a solvent-based adhesive, which is volatile and must be sealed and stored in a cool and dry place.

2. It is recommended to store used glue and unused glue separately to extend the storage period

3. After applying glue, let the glue evaporate completely before bonding, otherwise it may bubble.

4. During the bonding process, the substrate must be cleaned. If there is dirt or oil stains, it will cause non-stickiness. 5. If this product accidentally gets into your eyes, please wash it with clean water in time. Do not eat this product.

How to stick silicone to PC using W03 glue as an example

1. Surface treatment: Degrease the plastic by mechanical sandblasting or sandpaper polishing, or use alcohol chemical treatment.

2. Gluing: Use brushing or spraying, do not soak.

3. Drying: Bake at 90℃ for 10 minutes.

4. Parking: After gluing, it is advisable to bond as soon as possible, preferably on the same day. Avoid pollution and contact with high temperature and humidity air.

5. Vulcanization: Platinum vulcanizer is required for vulcanization, and the vulcanization temperature should not exceed 140℃.